Duct Wye Fitting Revit Family

Duct Wye Fitting Revit Family. Put that on the end of your duct and you can draw any pair of bends and ducts you like. My solution to this was to create a flat plate with a primary duct connection on one side and two secondary connections on the other.

Solved I would like duct fitting wye in this post. Who ever seen in from forums.autodesk.com

Then you can draw two elbows as you wish. Put that on the end of your duct and you can draw any pair of bends and ducts you like. If you make the two connectors on the split side scale from opposite corners (eg.

Source: www.turbosquid.com

Then you can draw two elbows as you wish. If you make the two connectors on the split side scale from opposite corners (eg.

Source: pkfasr329.weebly.com

Put that on the end of your duct and you can draw any pair of bends and ducts you like. Then you can draw two elbows as you wish.

Source: www.youtube.com

Then you can draw two elbows as you wish. My solution to this was to create a flat plate with a primary duct connection on one side and two secondary connections on the other.

Source: forums.autodesk.com

Then you can draw two elbows as you wish. My solution to this was to create a flat plate with a primary duct connection on one side and two secondary connections on the other.

Then You Can Draw Two Elbows As You Wish.

Put that on the end of your duct and you can draw any pair of bends and ducts you like. If you make the two connectors on the split side scale from opposite corners (eg. My solution to this was to create a flat plate with a primary duct connection on one side and two secondary connections on the other.

Location:

Share :